Khadas VIM2 Amlogic S912 3/64GB, AC WiFi Gig Lan, BT and VTV installed
Just a quick lots of test, shows it has sum get and go
At the present using a Custom rom by superceleron beta 1 and looking pretty good indeed,
Fast comes to mind…
Freaktab.com > http://freaktab.com/forum/tv-player-support/amlogic-based-tv-players/s912/others-aml-s912/firmware-roms-tools-by/665455-rom-khadas-vim-2-scv1-beta-normal-android
Available In ATV or Normal Android also found here.
- Supplied fan using existing VIM-1 lid will catch on the Glan GST chip and there will be a slight bend in lid cover.
Advised that New casing and Fan will be developed and a new housing for both Vim units…
I just nicked the cover of the Vim1 for now, some washers under corner to lift lid a couple of MM to remove the bend and all good for now and Heatsink from a Pi kit.
To Add to the Vim2 a bit of a show and tell of the VTV, DTV digital tuner
Well Packed and excellent looking Hardware
What’s In the Box
More as it happens
As Interesting as it may look, as one needs to work with what you have at hand.
All Mounted and ready to Walk out of here by the looks
After finding the missing 4th Leg we are now back to a more Normal Height
Temporary Fan Fix, down to about 32C at idle
So then I was thinking
What if you need to use the GPIO
So we flipped it
And mount Base Plate to finish the job
Also an attempt to run the DTV Software was not 100%
After the Updated Fix,
VTV would crash on startup and can go no further at the present.
All in Good time…
New Firmware in and installed today.
DTV looking Good
Excellent work by all
Did you check all modes of the signal, S/S2, T/T2 , Cable, did they all working well?
ONly FTA here T/T2 all good here.
Set Sound to HDMI for AC3 ~ HD channel in Android Settings.
— What do you mean by this ?
All channels had Audio Except for AC3.
AC3 audio is present ON the HD Channels In AU according to info
Needed to be enabled in Sounds setting of Android.
Can you explain better how you change Android settings to play AC3 sound on HD channels? A step by step or tutorial?
Digital Sounds set to HDMI
Think default was Auto