Rebuild fenix with armhf debian lxde ,can't load lightdm and can't into desktop

VIM2
1

I rebuild the lastest fenix (0.9.1) with this configuration:
PARAMETERS*
Fenix Version: 0.9.1
Khadas Board: VIM2
Uboot Version: 2015.01
Uboot Configuration: kvim2_defconfig
Uboot Branch: khadas-vims-v2015.01
Linux Version: 4.9
Linux Configuration: kvims_defconfig
Linux DTB: arch/arm64/boot/dts/amlogic/kvim2_linux.dtb
Linux Branch: khadas-vims-4.9.y
Distribution: Debian
Distribution Release: buster
Distribution Type: lxde
Distribution Arch: armhf
Install Type: EMMC
Final Image: VIM2_Debian-lxde-buster_Linux-4.9_armhf_EMMC_V0.9.1-20200606.img

the report apt can’t get sysbench,So I change the config file, and remove the sysbench from the PACKAGE_LIST_ADDITIONAL . then the rebild is successful. I bure this img into the device.But When I start the device , the system can’t load ligthdm .

image
image977×591 267 KB
this is the error

2

I have had this kind of error happen, but it was with a SD-USB image, my trick was using a fresh debian server image, and I just did,

sudo apt update && sudo apt upgrade
sudo apt install lxde/xfce/kde ##choose the required desktop environment

But I am not so sure about sysbench :confused:

3

ok,thanks I’ll try your way

4

I believe server version should have Lightdm installed already, but if not, it will install automatically

5

@hkax007 Hello, If you use VIMs, You should build with gnome or xface . lxde is used for Edge or Edge-V

6

I use the VIM2, I’ll try xface.Thanks