Nvme SSD doesn't work

nvme doesn’t work. The disk is detected when trying to format it - writes “input / output error”
Ubuntu Server
Linux Khadas 4.9

Hi, read the instructions…

Это все было сделано в самую первую очередь. Если переключится на USB режим - nvme устройство не определяется.
В данном же случае - оно определяется, но при попытке отформатировать или еще что-то сделать выдает всевозмодые ошибки
i/o error on dev nvme0n1p1, logical block 0, async page read,
… async page write,
buffer i/o error
input/output error during read …

This was all done first and foremost. If you switch to USB mode, the nvme device is not detected.
In this case, it is determined, but when you try to format or do something else, it gives all kinds of errors
i / o error on dev nvme0n1p1, logical block 0, async page read,
… async page write,
buffer i / o error
input / output error during read …

проверял саму ссд на другом устройстве.


Все с ней в порядке.
I checked the ssd itself on another device.
worked - ok.

Менял блоки питания (может беда с блоком), питался как от 5 вольтого так и от 24 вольтового блока питания. Не помогает
I changed the power supplies (maybe there is a problem with the unit), it was powered by both a 5 volt and a 24 volt power supply

В процессе разбора - натолкнулся на эту тему:

In the process of parsing - came across this topic:

However, as I understand it, there is a problem with the kernel> version 5.
In this case, the kernel version 4.9

На ядре 4.9 работает ограниченное количество NVME SSD. Гнусмасы в основном и WD. Все остальное дешевое -нет. Мой на чипе Silicon не работает хоть и определяется. Возьми Бубунту с сайта Khadas c ядром 5.7 - там NVME заработает с большей степенью вероятности (но отвалятся кое какие другие устройства - например TS050 панелька). Вообщем все сидят и ждут когда Khadas c Amlogic допилят mainline для Linux (как и AOSP 11)

1 Like

В krescure форматирует, правда во время форматирования возникают артефакты на мониторе.
uname -a
Linux Krescure 5.1.11
It formats in krescure, although artifacts appear on the monitor during formatting.
uname -a
Linux Krescure 5.1.11

Огромное спасибо за наводку!
Действительно заработало.
Однако дистрибутив только на флешку.
Я не очень понимаю всей глубины проблемы, но можно ли как-то этот дистрибутив предназначенный для флешки перенести emmc?
Что, я зря именно эту плату выбрал?

Thank you so much for the tip!
It really worked.
However, the distribution kit is only for a USB flash drive.
I do not really understand the depth of the problem, but is it possible somehow to transfer this distribution kit intended for a flash drive to emmc?
What, I shouldn’t have chosen this particular board?