I need connect a RF modem ethernet 10/100 output to EDGE processor via gold finger connector
DO I NEED a magnet or can be connected the 4 wire directly.
Thanks
I need connect a RF modem ethernet 10/100 output to EDGE processor via gold finger connector
DO I NEED a magnet or can be connected the 4 wire directly.
Thanks
The Edge SBC built-in Gigabit Ethernet PHY, but magnet still needed on carrier board, you can refer the schematic of Captain for the details.
Have fun!
Hi Gouwa
Sorry
I don’t Aggrey/Understand
the captian board is using the magnet for the ethernet connector to the outer world
I don’t need it .
my need is connecting the SBC to a my on-board RF modem pDDL2450.
Please advice.
Thanks
Shraga
Can you draw the connection in schematic or diagram to explain this?
Which interface, port or IO you’d like to use?
Hi Gouwa
I intend of using
GBE0_MDI0P, GBE0_MDI0N ,GBE0_MDI1P,GBE0_ MDI1N
signals
Attached My intensions for Lan connection
Thanks
Shraga