Poor VIM1 905x was feeling a bit neglected, as I pinched most the bits for the VIM2 monster
It was just a naked PCB, time for a a bit of Bling I feel.
As the Heat Sink was stuck on good I ultised the original Lid and Fan setup for now
Also slight reconfiguration to use New casing, I must say as much as I like the Coloured Cases,
I think the clear has that more Techo/Show off look that the coloured
So here we are in travel mode, plug it in and use it as is.
if we need to get to the GPIO for any reason pop the lid and all is easy to utilise
or can remove the cover, but for tone board, off with the LID.
Back view
Side View
Underneath, did not worry about steel plate, keeping the theme some clear feet.
Enjoy 